![]() ![]() The user will need to take sensible EMC precautions when designing the unit in and verify the overall system EMCperformance against any relevant standards. RoHS compliant.Īs the unit is designed for incorporation within the users system it is not tested against any specific EMC standards. HV negative: 45.3” (1150mm) fly wire, HRG58 coaxial HV cableĭesigned to meet IEC/UL 61010-1 Safety requirements for electrical equipment for measurement, control and laboratory use CAN/CSA-C22.2 No.61010-1. DC-DC Converters convert a direct current voltage input into a different direct current. HV positive: 45.3” (1150mm) fly wire, HRG58 coaxial HV cable Chassis Enclosed Enclosed, Bidirectional Enclosed, Conformal Coated Enclosed, High Voltage Front End Isolated Module Isolated Linear Regulator Replacement Open Frame. Iout=300μA maximumģ0mVpp, on an appropriate, properly connected ground referenced high voltage generatorġ.81˝ H X 5.74˝ W X 9.53˝ D (46mm X 139mm X 242mm The MCP module is easily customized to meet OEM requirements with improved ripple performance, improved stability and. The unit has remote voltage programming and a voltage monitor, and features low injected ripple when used with biasing supplies. If the reference supply is negative (up to -15kV), a 47MΩ pre-load resistor fitted within the MCP4 limits +VE (with respect to -VE) to ≤ 1400VĠ to 10 volt corresponds to 0 to 100% of rated output voltageĠ to 10 volts corresponds to 0 to 100% of rated output voltage. This +3kV 330uA high voltage DC DC converter module is packaged in a shielded metal enclosure. Note: When the unit output is set to zero and no load is connected: If the reference supply is positive (up to +15kV), +VE will always be less than 100V with respect to -VE. The MCP4 can be customized to meet OEMĠ to 4kV, continuously variable over the entire output range This unit has specifically designed to minimize crosstalk with the high voltage source which it is floated upon. A TTL compliant Enable signal provides simple control of the high voltage output. The unit has remote 0-10Vdc = 0-100% rated voltage programming and voltage monitor. This module is packaged in a shielded metal enclosure and the high voltage output is provided via two captive one meter long shielded coaxial cables. The MCP4 low output ripple specification and high stability make it ideal for use with detectors in Mass Spectrometry applications such as: Electron Multipliers (EM’s), Microchannel Plates Detectors (MCP’s) and Channel Electron Multipliers. Spellman’s MCP4 is a well-regulated, high performance DC-DC converter featuring a floating 4kV 600uA output, isolated to 15kV. MCP4 Model | High Voltage DC DC Converter ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |